Address: P. O. Box 1457, Los Gatos,
Tidbit - December 2011
Measuring the Resonant Frequencies Of Heat Sink Tines
(Your heat sink can be the source of high frequency EMC emissions!)
Is your product failing ESD testing?
Attend my webinar on sources of error in ESD testing. This webinar
covers problems and mistakes often made in testing products for ESD
compliance that can cause a good product to fail when it should pass.
The webinar is given as both a scheduled event and on-demand. Contact
me at firstname.lastname@example.org
for more details. Don't let your product fail ESD testing
unnecessarily. This webinar is an easy, cost effective solution.
Abstract: Heat sinks on ICs
can be a source of emissions at high frequencies in the multi-GHz
range. A method of identifying high risk frequencies by measuring the
resonant frequencies of the heat sink tines is discussed.
Many heat sinks
have tines that protrude perpendicularly from a base plate such as the
one shown in Figure 1. Today's clock frequencies are so high as to be
able to excite the tines as quarter wave monopoles resulting in
something like an antenna farm on top of the IC, potentially radiating
a clock harmonic or other source resulting in an emissions problem.
One way to measure the resonant frequency of physical structures in general and heat sink tines in particular is shown in the June 2006 Technical Tidbit, Measuring Structural Resonances
on this site. Basically, one would hold a very small shielded loop at
the base of one of the heat sink tines to couple energy into the tine.
By measuring the reflected signal from the small shielded loop, the
resonant frequency of a tine can be measured as the frequency where the
reflected signal experiences a dip as the tine absorbs energy from the
loop. The lowest frequency this would occur at is the frequency at
which the tine is 1/4 wavelength. The method is described in detail in
the June 2006 article referenced above. Figure 2 shows the method being
applied to a PCB test board mounted over a copper clad board. The
object in that case is to measure the resonant frequency of the LC
tuned circuit composed of the capacitor formed by the PCB and copper
clad board, and the inductance of the short wire between them.
Use of a Small Shielded Magnetic Loop to Measure PCB-Chassis Resonance
I observed a case some years ago where 4.7 GHz was leaking out of every
slot and seam in the enclosure of a product. It turned out that 4.7 GHz
was the third harmonic of the processor clock. When I measured the
resonant frequency of the hea tsink tines, the dip in the reflection
from the loop was right at 4.7 GHz indicating the tines were 1/4
wavelength monopoles, very efficient radiators, at that frequency. If
the tines had been longer or shorter the emissions problem would have
been reduced significantly.
Click here to see information on my upcoming seminar in Newport Beach, CA.
Need help with a design or additional training on technical subjects? Click on the image below to go to CircuitAdvisor.com
, a new engineering resource for training, news, and fun
If you like the information in this article and others on this website,
much more information is available in my courses. Click here
to see a listing of upcoming courses on design, measurement, and
troubleshooting of chips, circuits, and systems. Click here
to see upcoming seminars in Newport Beach, CA.
Click here for a description of my
latest seminar titled (now also available online as a WebEx seminar):
Lab Techniques for Designers
(How to find EMC problems and have some
confidence your system will pass EMC testing while it is still in your
Top of page
Questions or suggestions? Contact me at email@example.com
Copyright © 2011 Douglas C. Smith